Extreme Aspen

I posted this in the other forum also. I can't get cirrus to download a config from our Extreme Aspen switches running XOS.

We are currently running v4.0. I tried the template but it didn't help.

Here is the session trace.

-->StateChange: Connecting to server<--


-->StateChange: Connected to server - idle<--

Solarwinds.Net SWTelnet9 Version 9.0.27
Connected!
-->
--> telnet session telnet0 on /dev/ptyb0

-->
-->
-->
-->
ProcessLogin State: 3
-->
--> ExtremeXOS
--> Copyright (C) 2000-2006 Extreme Networks. All rights reserved.
--> Protected by US Patent Nos: 6,678,248; 6,104,700; 6,766,482; 6,618,388; 6,034,957; 6,859,438; 6,912,592; 6,954,436; 6,977,891; 6,980,550; 6,981,174; 7,003,705; 7,012,082.
--> ==============================================================================
-->
--> Press the <tab> or '?' key at any time for completions.
--> Remember to save your configuration changes.
-->
-->
ProcessLogin State: 3
-->CHS Aspen.1 #
ProcessLogin State: 3
Prompt is being set to : CHS Aspen.1 #
Logged into Router
<--

-->
-->
Process Line = <>
Process Line = <>
-->
--> CHS Aspen.1 #
Process Line = <>
Process Line = <CHS Aspen.1 # >
<-- disable clipaging

-->d
Process Line = <d>
Pushing back: <d>
mPrompt is : <CHS Aspen.1 # >
--> isable clipaging
-->
--> CHS Aspen.2 #
Process Line = <disable clipaging>
Echo recieveddisable clipaging
Process Line = <>
Process Line = <CHS Aspen.2 # >
<-- show conf detail

-->s
Process Line = <s>
Pushing back: <s>
mPrompt is : <CHS Aspen.1 # >
--> how conf detail
-->
-->                           ^
-->
--> %% Invalid input detected at '^' marker.
-->
--> CHS Aspen.3 #
Process Line = <show conf detail>
Echo recievedshow conf detail
Process Line = <>
Process Line = <                          ^>
Process Line = <>
Process Line = <%% Invalid input detected at '^' marker.>
Process Line = <>
Process Line = <CHS Aspen.3 # >
SendNextCommand Done: Disconnecting
TimerTick: mstrData=<CHS Aspen.3 # > State=3 - Connected to server - idle
Pending Disconnect = True
Disconnected - From: 192.168.32.1

 I figured it out, I had to make a small change to the template.

I had to change 

 <Command Name="Startup" Value="conf detail"/>
 <Command Name="Running" Value="conf detail"/>

to this

 <Command Name="Startup" Value="conf"/>
 <Command Name="Running" Value="conf"/>